Husqvarna R 322T AWD, Owner'S Manual

Page: 28 / 40

28 –
English
Maintenance
8 Fit the drive belt around the drive wheels of the cutting
unit. Make sure the belt is placed on the correct side of the
belt tensioner wheel.
9 Hook up the height adjustment strut.
10 Secure the collet spring.
11 Fit the front cover.
Removing the cutting unit
1 Carry out points 1-6 to put the cutting unit in the service
position, see Service position for the cutting unit.
2 Lower the cutting unit.
3 Open the unit catch.
4 Pull out the cutting unit.
Checking and adjustment of the
cutting unit’s ground pressure
To achieve the best cutting results the cutting unit should
follow the underlying surface without pressing too hard
against it.
Pressure is adjusted using a screw and spring on each side
of the Rider.
1 Check the air pressure in the tyres 60 kPa/0.6 kp/cm
2
/8.5
PSI.
2 Place the machine on a flat surface.
3 Put the lifting lever in the mowing position.
4 Place a set of bathroom scales under the cutting unit’s
frame (front edge) so that it rests on the scales. If
necessary a block can be placed between the frame and
scales so that the support wheels do not bear any weight.
5 Adjust the unit’s ground pressure by screwing in or out the
adjusting screws located behind the front wheels on both
sides. The ground pressure should be between 12 and 15
kg (26.5-33 lb).
!
WARNING! Wear protective glasses when
dismantling the cutting unit. The spring
which tensions up the belt may break and
cause personal injury.
!
WARNING! Observe caution to avoid
trapping your hand.