Husqvarna R 316TsX, Operator'S Manual

Page: 18 / 37

4. To release the parking brake, press the parking
brake pedal again.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
schedule. Refer to
Maintenance schedule on page
94 .
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, see
Technical data on page
109 ). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
cutting result also at a higher speed.
• Cut the grass in an irregular pattern.
• To get the best cutting result, cut the grass
frequently and use the BioClip function.
Maintenance
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Maintenance Daily maintenance
before operation
Maintenance interval
in hours
25 50 100 200
Make sure that nuts and screws are tightened *
Make sure that there are no fuel or oil leaks *
Clean as given in
To clean the product on page 95
X
Clean the inner surface of the cutting deck, around the blades X
Clean around the muffler X
Make sure that the cold air intake of the engine is not blocked X
Make sure that the safety devices are not defective X
Examine and do a test of the brakes X
Do a check of the engine oil level X
Do a check of the oil level in the transmission X
Do a check of the steering wires X
Examine the blades in the cutting deck X
Clean the cutting deck, below the belt covers and below the cutting
deck
X
Make sure that the tire pressure is correct X X
Do a check of the parking brake X
Replace the engine oil
13
X
Replace the oil filter X
13
Replace the engine oil first time after 8 hours of operation.
94 844 - 002 -