Husqvarna QT3581K, User Manual

Page: 17 / 24

7.4 Removing the transport support
2
3
Your appliance is equipped with trans-
port support to secure the door during
transportation.
To remove them do these steps:
• Open the door.
• Remove the transport support from
the door sides.
• Remove the transport support from
the lower hinge (some models).
Some models are fitted with a si-
lencing pad under the cabinet.
Do not remove this pad.
7.5 Rear spacers
• Install the spacers provided within the
accessory bag as shown in the figure.
• Install the spacers on the brackets of
the condenser (black grill) at the back
of the appliance.
7.6 Connecting the water
hose.
Water supply should be provided with a
tap and 3/4" male connector within 1,5
m from the appliance.
This work is to be carried out by a skilled
plumber.
There are different type-approved taps
and tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
If this appliance has been purchased to-
gether with the corresponding fridge the
installation should be conducted in such
a way that both appliances share the
safety valve supplied with the fridge.
Should this appliance instead have been
purchased as a single installation or to-
gether with an appliance without water
connection, it is strongly recommended
that a safety valve (1504516–00/4) is in-
stalled. This item can be ordered via
www.electrolux.com.
Before the appliance is placed in its final
location, ensure that the water connec-
tion has been correctly carried out and
that there is no leakage at the connec-
tion to the water tap.
Tighten the connections by hand only.
ENGLISH
17