Problem
Possible cause
Remedy
The fuse is blown.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
You do not set the heat set‐
ting for 50 seconds.
Activate the hob again and set
the heat setting in less than 50
seconds.
You touched 2 or more sen‐
sor fields at the same time.
Touch only one sensor field.
Pause operates.
Refer to "Daily use".
There is water or fat stains
on the control panel.
Clean the control panel.
You cannot select the
maximum heat setting for
one of the cooking zones.
The other zones consume
the maximum available pow‐
er.
Your hob works properly.
Reduce the heat setting of the
other cooking zones connec‐
ted to the same phase.
Refer to "Power manage‐
ment".
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
You put something on one or
more sensor fields.
Remove the object from the
sensor fields.
The hob deactivates.
You put something on the
sensor field .
Remove the object from the
sensor field.
Residual heat indicator
does not come on.
The zone is not hot because
it operated only for a short
time or the sensor is dam‐
aged.
If the zone operated sufficient‐
ly long to be hot, speak to an
Authorised Service Centre.
Hob²Hood does not work. You covered the control pan‐
el.
Remove the object from the
control panel.
You use a very tall pot which
blocks the signal.
Use a smaller pot, change the
cooking zone or operate the
hood manually.
The sensor fields become
hot.
The cookware is too large or
you put it too near to the
controls.
Put large cookware on the rear
zones, if possible.
There is no sound when
you touch the panel sen‐
sor fields.
The sounds are deactivated. Activate the sounds.
Refer to "Daily use".
www.husqvarna-electrolux.se
36
Summary of Contents for QHIO660P
Page 59: ......
Page 60: ...www husqvarna electrolux se shop 867358273 A 252020 ...
