3. Put the cutting blade on the arbor bushing (A)
between the inner flange washer (B) and the flange
washer (C). Turn the flange washer until it holds on
to the shaft.
A
B
C
4. Put a tool into the hole in the front belt guard and
turn the cutting blade until the shaft is locked.
5. Tighten the cutting blade bolt to 25 Nm/18.5 ft-lb.
To reverse the cutting head
WARNING:
Only cut with the cutting
head reversed if a standard procedure is not
possible.
The product has a reversible cutting head that lets you
cut near a wall or at ground level. Only cut with the
cutting head reversed if a standard procedure is not
possible. If a kickback occurs, it is more difficult to
control the product if the cutting head is reversed. The
distance between the cutting blade and the center of the
product is longer, which means that the handle and the
cutting blade do not align. This has a negative effect on
the balance in the product and it is more difficult to hold
the product if the cutting blade is pinched or stalled in
Kickback zone on page 17
.
WARNING:
Make sure that the motor is
off and that the power plug is disconnected.
WARNING:
Always use protective
gloves when you assemble the product.
1. Remove the cutting blade, refer to
cutting blade on page 15
.
2. Loosen the 2 bolts and the adjuster to release the
belt tension.
3. Remove the bolts and release the belt guard.
4. Disconnect the water hose nipple, the water hose
and the handle from the blade guard. Remove the
stop.
5. Remove the belt from the pulley.
16
1635 - 003 - 20.08.2021
Summary of Contents for K 7000
Page 125: ...1635 003 20 08 2021 125 ...
Page 126: ...126 1635 003 20 08 2021 ...
Page 127: ...1635 003 20 08 2021 127 ...