b) Lift and remove the governor rod.
7. Remove the governor rod (A) from the governor arm
(B).
A
B
8. Remove the carburetor and related gaskets and
insulator.
9. Install in the opposite sequence.
6.5.3 To disassemble the carburetor
1. Remove the air filter holder. Refer to
install the air filter holder on page 20.
2. Clean the external surface of the carburetor. Refer
to
To clean and examine the carburetor on page
26.
3. Remove the screw (A) and the float bowl gasket.
D
B
A
C
4. Remove all fuel from the float bowl (B).
5. Remove the hinge pin (C) and remove the float (D)
and the float needle valve.
1425 - 001 - 03.06.2020
Repair instructions- 25
