Husqvarna FS 600 E, Operator'S Manual

Page: 12 / 452

CAUTION:
Always use a sharp
diamond blade.
There is a wide range of diamond blades that is used
for different operations. From new made concrete to
concrete and asphalt that has become hard and for
different hardness classes.
Diamond blades has a steel core with segments that are
made of industrial diamonds.
Water cooling system
Always use water during operation to keep the
temperature of the diamond blades down. The water
cooling system also increases the lifetime of the
diamond blades and prevents dust buildup.
Make sure that the water supply is not clogged.
Diamond blades for wet cutting
WARNING:
Always use a blade flange
dimension that is specified for the current
blade dimension. Do not use blade flanges
that are damaged.
During the operation, the friction causes the diamond
blade to become very hot. If the diamond blade
becomes too hot, it will decrease the blade tension or
make the core crack.
Let the diamond blade become cool before you touch it.
• Diamond blades for wet cutting must be used with
water to keep the diamond blade core and segments
cool during cutting. Diamond blades for wet cutting
can not be used dry.
• If you use diamond blades for wet cutting without
water, the diamond blade can become too hot. This
gives bad performance, blade damage and is a
safety risk.
To adjust the handle height
The height of the handle can be adjusted to the correct
height.
1. Loosen the screws (A) on each side of the product.
B
A
2. Set the position for the necessary work height (B).
3. Tighten the screws (A).
To install a cutting blade
The cutting blade can be installed on the right side and
the left side of the product.
CAUTION:
Risk of damage to the
cutting blade if it is installed opposite to
the direction of rotation. Make sure that the
cutting blade rotates in the direction of the
arrows shown on the cutting blade.
Note:
The lever for the cutting depth wheel must
always be locked when the cutting depth wheel is not
in use.
1. Stop the motor and disconnect the product from the
mains socket.
12 1620 - 004 -