Husqvarna FS 600 E, Operator'S Manual

Page: 15 / 452

b) Put the blade guard latch on the front bolt of the
blade guard. Tighten the front bolt (A).
CAUTION:
Do not operate the
product without the blade guard latch
engaged. Do not use the product if the
parts are damaged.
3. Use the handle (D) to lift the blade guard and install
the blade guard onto the support (E).
E
D
4. Install the screw (F) for the blade guard.
F
G
5. Connect the water hose (G).
6. Install the flange cover on the opposite side of the
product and tighten the 2 screws.
To remove the blade guard
1. Stop the motor. Refer to
To stop the product on page
19 .
2. Remove the blade guard in the opposite sequence
of how it was installed. Refer to
To install the blade
guard on page 14
.
To set the cutting depth indicator
The indicator must be calibrated before you use the
product.
Note:
The lever for the cutting depth wheel must
always be locked when the cutting depth wheel is not
in use.
1. Turn the cutting depth wheel until the cutting blade
slightly touches the ground. Push the lever to lock
the cutting depth wheel.
1620 - 004 - 15