TUNING THE CHASSIS 10
41
Guideline
Rebound damping
Comfort
17 clicks
Standard
12 clicks
Sport
7 clicks
Info
Turn clockwise to increase damping; turn counter-
clockwise to reduce damping.
–
Mount protection cap
1
.
10.16
Handlebar position
800116-10
On the upper triple clamp, there are 2 holes at a distance of
A
to each other.
Hole distance A
15 mm (0.59 in)
The holes on the handlebar supports are placed at a distance
of
B
from the center.
Hole distance B
3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
10.17
Adjusting the handlebar position
Preparatory work
–
Remove the handlebar cushion.
B00375-10
Main work
–
Remove screws
1
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
Remove screws
2
. Take off the handlebar supports.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
2
.
Guideline
Screw, handle-
bar support
M10
40 Nm (29.5 lbf ft)
Loctite
®
243™
–
Position handlebar.
https://www.motorcycle-manual.com/
