12 SERVICE WORK ON THE CHASSIS
88
F00454-10
–
Fill bleeding syringe
4
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 (
–
On the clutch slave cylinder, release bleeder screw
5
and
mount bleeding syringe
4
.
K00610-10
–
Now press the fluid into the system until it emerges from the
hole
6
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
12.46
Removing the engine guard
H01655-01
–
Remove screws
1
and engine guard.
12.47
Installing the engine guard
H01655-01
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis
M6
10 Nm (7.4 lbf ft)
