Husqvarna FE 350 2021, Owner'S Manual, Page: 90 / 169

12 SERVICE WORK ON THE CHASSIS
88
S03565-10
–
Fill bleeding syringe
4
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
p. 155)
–
On the clutch slave cylinder, remove bleeder screw
5
and
mount bleeding syringe
4
.
H03715-10
–
Now press the fluid into the system until it emerges from
hole
6
of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Remove the bleeding syringe. Mount and tighten the bleeder
screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim 4 mm (0.16 in)
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Immediately clean up any brake fluid that has over-
flowed or spilled with water.
12.45 Removing the engine guard
H01655-01
–
Remove screws
1
and engine guard.
12.46 Installing the engine guard
H01655-01
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis M6 10 Nm (7.4 lbf ft)