Husqvarna FC 250, Owner'S Manual, Page: 70 / 149

11 SERVICE WORK ON THE CHASSIS
68
S02040-11
–
Mount and tighten screws 2 .
Guideline
Remaining screws,
chassis M6 10 Nm (7.4 lbf ft)
S02038-11
–
Plug in connector
3
for the fuel pump.
–
Remove the wash cap set and thoroughly clean the plug-in
connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
–
Lubricate the O-ring and connect plug-in connection
4
for
the fuel line.
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
Finishing work
–
Mount the seat. ( p. 60)
–
Install the air filter box cover. ( p. 61)
–
Install the right side cover. ( p. 65)
11.34 Checking for chain dirt accumulation
400678-01
–
Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
–
Clean the chain. ( p. 68)
11.35 Cleaning the chain
Warning
Danger of accidents Oil or grease on the tires reduces the road grip.
–
Remove the lubricant from the tires using a suitable cleaning agent.