Husqvarna F2401V5, Owner'S Manual

Page: 91 / 152

BRAKE SYSTEM 12
89
V02134-10
Main work
–
Position the vehicle vertically.
–
Remove screw cap
1
with membrane
2
and the O-ring.
–
Add brake fluid up to the marking
A
.
Brake fluid DOT 4 / DOT 5.1 ( p. 139)
–
Mount and tighten the screw cap with the membrane and O-
ring.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
12.11 Checking the brake linings of the rear brake
Warning
Danger of accidents
Worn-out brake linings reduce the braking effect.
–
Ensure that worn-out brake linings are replaced immediately. (Your authorized Husqvarna Motorcy-
cles workshop will be glad to help.)
V02133-10
–
Check the brake linings for minimum thickness
A
.
Minimum thickness
A
≥
1 mm (
≥
0.04 in)
» If the minimum thickness is less than specified:
–
Change the rear brake linings. ( p. 89)
–
Check the brake linings for damage and cracking.
» If damage or wear is encountered:
–
Change the rear brake linings. ( p. 89)
12.12 Changing the rear brake linings
Warning
Danger of accidents Incorrect servicing will cause the brake system to fail.
–
Ensure that service work and repairs are performed professionally. (Your authorized Husqvarna
Motorcycles workshop will be glad to help.)
Warning
Skin irritation
Brake fluid causes skin irritation.
–
Keep brake fluid out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
–
Consult a doctor immediately if brake fluid has been swallowed.
–
Rinse the affected area with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
–
If brake fluid spills on to your clothing, change the clothing.