Husqvarna DSS 200, Workshop Manual

Page: 27 / 32

Hydraulic swivel piston 10
10.Hydraulic swivel piston
23
PREPARATIONS
•
Remove orbital motor and flanges as de-
scribed in previous chapter.
Dismantling swivel piston
1. Remove piston clamping flange (I)
•
remove 9 × fasteners
–
8 mm Allen wrench
Reassembling: use thread locking compound
T1 (Medium) to fasteners.
Tightening torque: 51 Nm
2. Remove flange and roller bearing
I. lift off clamping flange
II. take care of radial shaft seal
–
replace if worn or damaged
III. remove needle bearing with sup-
port washers – one on either side
3. Gently pull out swivel piston
4. Swivel female unit
•
hydraulic fluid openings and groves
+ hydraulic fluid pressure
- hydraulic fluid return
G grease flow from head nipple
5. Swivel male unit
•
hydraulic fluid openings
•
grease openings and groves
6. Principles for flow of hydraulic li-
quid and grease:
•
hydraulic pressure (+) and return (-)
lines
•
lubricating grease (G) line from
nipple through openings and groves
Continue dismantling on next page...
51 Nm
8 mm