WIRING DIAGRAM, CABLING – 120 V
Assembly diagram
The assembly diagram shows the colours
and positions of the connection cables
for the electrical connections.
Component placement
Figure 1
The figure shows the position of the
cables in the motor housing when the
cover is removed.
Note the earth cable is attached with a
screw to the gear box cover.
The two black cables (a) lead to the
circuit breaker at the circuit board.
Figure 2
The cable (b) from the stator must be
attached to the upper bracket. The cables
to the speed sensor are to lie under the
stator cable.
Figure 3
The figure shows how the cables are
attached to the circuit board. The stator
cable (b) and the short connection (c)
between the circuit board and carbon
brush on the right-hand side, seen from
behind.
Figure 4
Note how the cables (a) are to lie in the
slot.
Figure 5
The figure shows the cable routing in the
motor housing and the connections to
the circuit board. View from the left side
seen from behind.
Figure 6
Detail from figure 5.
Note that both the stator cables (d) are
connected to this carbon brush holder.
1
2
a
b
3
5
6
4
Rotor
Stator
Stator
GREY
GREY
GREY
RED
BLACK
BLACK
YELLOW
GREY
BLACK
BLACK
BLACK
BLACK
PrintedCir
cuit Assembl
y
Residual Current Device
BROWN
BLUE
GREEN/YELLOW
b
c
c
12
17
a
b
d
d
