ASSEMBLY
52 – English
locking pin (C). Place the locking pin in the groove on
the screw head and tighten. See diagram.
•
Fit the drive disc (B) on the output shaft.
•
Centre the metal cup (P) on the drive disc’s blade
guide.
•
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head (H) in the opposite
direction to the direction of rotation.
•
Tighten the trimmer head to a torque of 35-50 Nm
(3.5-5 kpm).
•
To dismantle, follow the instructions in the reverse
order.
Fitting other guards and cutting
attachments
•
Fit the trimmer guard/combination guard (A) intended
for use with the trimmer head/plastic blades. Hang the
trimmer guard/combination guard (A) on the two
hooks on the plate holder (M). Bend the guard around
the shaft and tighten it with the bolt (L) on the opposite
side of the shaft. Use the locking pin (C). Place the
locking pin in the groove on the screw head and
tighten. See diagram.
•
Fit the drive disc (B) on the output shaft.
•
Centre the metal cup (P) on the drive disc’s blade
guide.
•
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
•
To dismantle, follow the instructions in the reverse
order.
Adjusting the harness and brush
cutter
Standard harness
Safety release
At the front is an easily accessible, quick release. Use this
if the engine catches fire or in any other emergency
L
A
M
C
B
H
P
C
H
C
!
WARNING! When using a brush cutter it
must always be hooked securely to the
harness. Otherwise you will be unable to
control the brush cutter safely and this
can result in injury to yourself or others.
Never use a harness with a defective
quick release.
L
A
M
C
B
H
P
C
