5. Install the air filter cover with the screws.
To disassemble and assemble the
vibrator head
1. Remove the end cap (A) and the tube connector (B)
from the tube.
A
B
Note: The end cap has a right hand thread. The tube
connector has a left hand thread.
2. Use a screwdriver to lock the eccentric element, put
the screwdriver into the groove at the end with the
end cap. Loosen the square screw cap (C).
C
3. Remove the eccentric element (D) and the 2
bearings (E) from the tube.
D
E
E
4. Push the 2 bearings (F) out of the tube.
F
F
5. Examine the 4 bearings, replace the bearings that
are worn or damaged.
6. Assemble the vibrator head in the opposite
sequence.
Troubleshooting
Problem
Cause
Solution
The product does not
start.
The power plug is not connected.
Connect the power plug into a power socket.
The power switch is in the OFF position.
Turn the power switch to the ON position.
The carbon brushes are worn out.
Replace the carbon brushes.
There is no power in the power socket.
Replace or repair the power socket.
The power switch is defective.
Replace the power switch.
10
1154 - 001 - 05.03.2020
