Husqvarna 585, Operator'S Manual

Page: 15 / 132

WARNING:
Only you and the correct
working technique can prevent kickbacks.
To start the product
To prepare to start
WARNING:
The chain brake must be
engaged when the product is started to
decrease the risk of injury.
1. Move the front handguard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up.
a) 585: Set the start/stop switch in choke position.
b) 592 XP, 592 XPG: Set the start/stop switch in
start position.
3. Push the decompression valve (B).
Note:
The decompression valve moves to the
initial position when the product starts.
4. Push the air purge bulb (C) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
A
C
B
5. Continue to
To start the product on page 15
for
more instructions.
To start the product
WARNING:
You must keep your feet in
a stable position when you start the product.
WARNING:
If the saw chain rotates at
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
Do not twist the starter
rope around your hand.
5. Pull the starter rope handle quickly and with force
until the engine starts.
CAUTION:
Do not pull the starter
rope to full extension and do not let go of
the starter rope handle. This can cause
damage to the product.
6. Disengage the choke on 585.
Note:
The choke is disengaged automatically on
592 XP and 592 XPG.
7. Quickly disengage the throttle trigger lockout to set
the product to idle speed.
1471 - 001 - 18.02.2021 15