WARNING:
Only you and the correct
working technique can prevent kickbacks.
To start the product
To prepare to start with a cold engine
WARNING:
The chain brake must be
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up to set it in
choke position.
3. Press the air purge bulb (B) about 6 times or until
fuel starts to fill the bulb. It is not necessary to fill the
air purge bulb fully.
(A)
(B)
4. Continue to
To start the product on page 13
for
more instructions.
To prepare start with a warm engine
WARNING:
The chain brake must be
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up to set it in
choke position.
3. Press the air purge bulb (B) about 6 times or until
fuel starts to fill the bulb. It is not necessary to fill the
air purge bulb fully.
4. Press down the start/stop switch (C) to set start
throttle setting.
(A)
(C)
(B)
5. Continue to
To start the product on page 13
for
more instructions.
To start the product
WARNING:
You must keep your feet in
a stable position when you start the product.
WARNING:
If the saw chain rotates at
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
Do not twist the starter
rope around your hand.
5. Pull the starter rope handle quickly and with force.
544 - 009 - 07.02.2022
13
Summary of Contents for 545 Mark II
Page 126: ...126 544 009 07 02 2022 ...
Page 127: ...544 009 07 02 2022 127 ...