WORKING TECHNIQUES
82 – English
•
Use the harness to support the weight of the machine
and make it easier to handle.
•
If any foreign object is hit or if vibrations occur stop the
machine immediately. Disconnect the HT lead from
the spark plug. Check that the machine is not
damaged. Repair any damage.
•
If anything gets caught up in the cutting equipment
while you are working, switch off the engine and let it
stop completely and remove the ignition lead before
cleaning the cutting equipment.
•
This machine is not electrically insulated. If the
machine touches or comes close to high-voltage
power lines it could lead to death or serious bodily
injury.
Safety instructions after completing work
•
The transport guard should always be fitted to the
cutting attachment when the machine is not in use.
•
Make sure the cutting attachment has stopped before
cleaning, carrying out repairs or an inspection.
Disconnect the spark plug cap from the spark plug.
•
Always wear heavy-duty gloves when repairing the
cutting attachment. This is extremely sharp and can
easily cause cuts.
•
Store the machine out of reach of children.
•
Use only original spare parts for repairs.
Basic working techniques
•
Hold the machine as close to your body as possible to
get the best balance.
•
Make sure that the tip does not touch the ground.
•
Do not rush the work, but work steadily until all the
branches have been cut back cleanly.
•
Always slow the engine to idle speed after each
working operation. Long periods at full throttle without
any load on the engine can lead to serious engine
damage.
•
Always work at full throttle.
•
Let the engine drop back to idle speed between each
cut. Long periods at full throttle can cause serious
damage to the centrifugal clutch.
Observe great care when working close to overhead
power lines. Falling branches can result in short-
circuiting.
!
WARNING! Never stand directly
underneath a branch that is being cut.
This could lead to serious or even fatal
personal injury.
!
WARNING! Observe the applicable safety
regulations for work in the vicinity of
overhead power lines.
