2. Tighten the bar nuts by hand as tightly as
you can.
3. Lift the front of the guide bar and turn the
chain tensioning screw. Use a combination
wrench.
4. Tighten the saw chain until it is tight
against the guide bar but still can move
easily.
5. Tighten the bar nuts using the combination
wrench and lift the front of the guide bar at
the same time.
6. Make sure you can pull the saw chain
around freely by hand and that it does not
hang from the guide bar.
To fill with chain oil
1. Open the oil cap on top of the bar head.
2. Fill with Husqvarna saw chain oil.
3. Attach the cap again.
To check the chain lubrication
1. Start the product. Refer to
2. Point the tip of the bar at a light surface.
3. Keep a distance of 20 cm (8 inches).
4. Operate the throttle at 75% for 1 minute.
5. Stop the product. Refer to
6. Make sure that you can see a line of oil on
the light surface.
CAUTION:
Do a check of
the guide bar if the saw chain
lubrication does not operate
page 22 for instructions. Speak
to your servicing dealer if the
maintenance steps does not
help.
To adjust the chain lubrication
WARNING:
Stop the engine
before you make adjustments to the
oil pump.
26
1824 - 003 - 28.06.2022
Summary of Contents for 525DEPS
