English
– 17
ASSEMBLY
Transport position, handlebar (240R,
240F, 250R, 252RX)
•
The handlebar can easily be turned to fit along the shaft
for easier transportation and storage.
•
Loosen the knob. Turn the handlebar clockwise so that the
throttle handle rests against the engine.
•
Now twist the handlebar around the shaft. Tighten the
knob.
•
Fit the transport guard to the cutting attachment.
Fitting the handlebar (265RX)
•
Fit the left handlebar in the handlebar mounting.
•
Fit the right handle to the handlebar.
•
Adjust roughly and tighten the screws slightly.
•
Now make a final adjustment, with the machine hanging
from the harness, to obtain the most comfortable working
position. Tighten the screws.
•
Make the final adjustment to the right handle and lock it in
the most comfortable position.
Adjusting the throttle trigger
The throttle trigger can be adjusted to give the best working
position. This is done using the Allen screws by the right
handle.
Assembling the cutting equipment
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
