Husqvarna 2008 HUV 4213-G, Owner'S Manual

Page: 35 / 52

Engine Oil
10. Remove the engine oil filter, turning it counterclockwise, allowing the residual oil in the filter port and filter to
drain into the oil drain pan. See following NOTE
NOTE: An oil drip guard can be used to prevent excess oil from dripping into the engine base place. Use an empty
quart (one liter) container and cut the bottom off at an angle, then slide the open area of the container up and
under the oil filter prior to removing. Position the port of the plastic container so oil will be directed into the oil
pan
(Figure 20, Page 33) . A drip guard can be made by folding a piece of cardboard, thin metal, or plastic
under the oil filter forming a channel to direct the filter port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
11. Use a clean, lint-free rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
12. Install a new oil filter (P/N 603 00 00-06) onto the engine oil filter port. Apply a light coat of white lithium NLGI
Number 2 grease (Dow Corning ® BR2-Plus or equivalent) or new engine oil to the rubber seal around the outside
surface of the filter before attaching it to the oil filter port (Figure 21) . This will help seal the filter to the oil filter
mounting bracket. See following NOTE.
NOTE: Use only Husqvarna oil filters (P/N 603 00 00-06) designed for this engine.
1
3
2
1. Snubber Bracket 2. Snubber 3. Compress Down
171
Figure 19 Compress Snubber Downward
26
Figure 20 Remove Engine Oil Filter
2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual Page 33