20
www.usa.husqvarna.com
Troubleshooting
Problem
Cause
Correction
Engine is running, but no AC
output is available.
1. One of the circuit breakers is open.
2. Fault in generator.
3. Poor connection or defective cord set.
4. Connected device is bad.
1. Reset circuit breaker.
2. Contact authorized service facility.
3. Check and repair.
4. Connect another device that is in good
condition.
Engine runs good at no-load but
“bogs down” when loads are
connected.
1. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
1. Disconnect shorted electrical load.
2. See
Don’t Overload Generator
in
Operation
section.
3. Contact authorized service facility.
Engine will not start; or starts
and runs rough.
1. Fuel Valve is in “
Off
” position.
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
1. Turn fuel valve to “
Open
” position.
2. Fill fuel tank.
3. Drain fuel tank and carburetor; fill with
fresh fuel.
4. Drain fuel tank and carburetor; fill with
fresh fuel.
Engine shuts down when
running.
Out of fuel.
Fill fuel tank.
Engine lacks power.
Load is too high.
See
Don’t Overload Generator
in
Operation
section.
