Husqvarna 132R, Operator'S Manual

Page: 12 / 36

12 –
English
ASSEMBLY
Fitting the main body
Connect the engine (A) to the tube (B) with four screws (C).
Assembling the handlebar and
throttle
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole in
the handlebar.
• Re fi t the screw in the hole in the rear of the throttle handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Fit the handlebar in the handlebar clamp on the shaft
using six screws.
• Attach the cabling to the shaft with two cabling holders.
(142R/143R)
• Put on the harness and hang the machine from the
support hook. Now make a
fi nal adjustment so that the
machine is in a comfortable working position when it
hangs from the harness. Tighten the knob.
Fitting blades and trimmer heads
Fitting the cord cutter and guard
extension to the trimmer guard
142R
CAUTION! The guard extension shall always be fi tted when
using the trimmer head/plastic blades and combination
guard. The guard extension shall always be removed when
using the grass blade and combination guard.
1 Attach the cord cutter (A) to the trimmer guard using two
M5x25 screws, locking washers and nuts as shown.
2 Fit the guard extension (B) to the trimmer guard using the
fi ve M5x25 screws, washers and nuts as shown.
A
B
C
C
!
WARNING!
When fi tting the cutting attachment it is
extremely important that the raised section
on the drive disc/support
fl ange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is
fi tted
incorrectly it can result in serious and/or
fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is
fi tted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.