Husqvarna 125 TC EU, Owner'S Manual

Page: 36 / 109

11 SERVICE WORK ON THE CHASSIS
34
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on
the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
–
Clean and oil the dust boots and inner fork tube of both fork legs.
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Position the fork protection. ( p. 34)
–
Remove the motorcycle from the lift stand. ( p. 33)
11.5 Loosening the fork protection
B01849-10
–
Remove screws
1
and take off the clamp.
–
Remove screws 2 on the left fork leg. Push the fork protection downwards.
–
Remove the screws on the right fork leg. Push the fork protection downwards.
11.6 Positioning the fork protection
B01849-11
–
Position the fork protection on the left fork leg. Mount and tighten screws 1 .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position the brake line. Position the clamp and mount and tighten screws
2
.
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
11.7 Removing the fork legs
x
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 33)
–
Remove the front wheel.
x
( p. 65)
B00300-10
Main work
–
Remove screws
1
and take off the clamp.
–
Remove screws 2 and take off the brake caliper.
–
Allow the brake caliper and brake line to hang tension-free to the side.
Info
Do not activate the hand brake lever while the front wheel is removed.
L01911-10
–
Unscrew screws 3 . Take out the left fork leg.
–
Unscrew screws
4
. Take out the right fork leg.