16
THREADING THE UPPER THREAD
Threading is simple but
it is important to thread
correctly to prevent
sewing problems could
result.
-
Start by raising the
needle to its highest
point (1), and also
raise the presser foot
to release the tension
discs. (2)
Attention:
For safety, it is strongly
suggested you turn
off the power before
threading.
-
Lift up the spool pin. Place the spool
of thread on the holder with the thread
coming off the spool as shown. For
small thread spools, place small side of
spool holder next to spool. (3)
-
Draw thread from spool through the
upper thread guide. (4)
-
Guide thread around thread guide
(5) pulling thread through pre-tension
spring as illustrated.
-
Thread tension disks by leading thread
down in right channel and up in left
channel (6). During this process it is
helpful to hold the thread between the
spool and thread guide (4).
-
At the top pull thread from right to left
through the slotted eye of the take-up
lever and then down again. (7)
-
Place thread behind the thin wire
needle clamp guide (8) and then down
to the needle eye and thread from front
to back.
-
Pull about 6-8 inches of thread under
the presser foot to the back. Trim
thread to length with built in thread
cutter. (9)
Summary of Contents for H Class E10
Page 1: ...E10 USER S GUIDE ...
Page 34: ......
