HUSLOG
EN
HUSLOG
15
8. USE
All operations should be carried out gently so as not to damage the components.
CHARGING THE BATTERY
Charge the battery to the full before the first use. Several charging and discharging
cycles may be necessary to achieve full battery capacity.
The device cannot be used during charging.
When the battery level is low, the backlight under the on/off button will quickly flash
red when switching on and trying to use the device.
The battery can be charged using a USB charger, power bank or from the USB port of
your computer (devices are not a part of offer, not included). To start charging, remove
the cap from the micro USB socket of the dispenser, located on the left side of the
device, then plug the USB cable (included) into the micro USB connector. Plug the
second end of USB rack to the power supply.
The start of charging will be indicated by
the red power button lighting up. The button illumination will change to green when the
battery charge level reaches approx. 90%. It takes 3 h 30 m to fully charge a fully
exhausted battery. After this time, unplug the USB cable from the device and close the
micro USB socket cap.
FILLING THE SOAP CONTAINER
Pour in the soap carefully so as not to contaminate the device. When filling the tank,
we recommend using a funnel (not included).
Make sure the unit is turned off. Place the dispenser vertically on a stable surface in a
place where there is no risk that the soap being poured will contaminate household
equipment which should not come in contact with it. Unscrew the upper part of the
dispenser by turning it counter clockwise. Then take it off and put it in a safe place.
Pour the soap carefully through the soap tank opening. We recommend using a funnel
to reduce the risk of spills or leakage. Pour in the soap max. to the level of the tank
opening. If any amount of soap contaminates the soil around the opening, wipe off any
excess with a paper towel or dry cloth. Place the upper part of the dispenser to match
the hooks to the holes in the soap container. Then tighten the upper part of the
dispenser by turning it clockwise.
Maximum fill
level
