SPECIFICATIONS
• This appliance is a cellar compartment for the storage of non-
perishable beverages. It is not suitable for the storage of fresh food
or perishable drinks.
• It is intended strictly for domestic indoor use.
• The refrigerating circuit is leak-proof.
HOW TO MINIMISE THE ENERGY CONSUMPTION OF YOUR
HUSKY DRINKS COOLER
• Energy consumption will be lower if the unit stands in a well
ventilated space and in particular if vent at the back of the unit is
clear of obstruction.
• Do not place the appliance in direct sunlight or near a heat source
such as ovens, radiators, heaters, etc as this will increase energy
consumption.
• Keep the door closed as much as possible.
• Setting the thermostat cooler (towards 5 on the dial) means higher
energy consumption, so set only as cool as you really require.
• Do not overfill the cabinet - overfilling means that the cool air cannot
circulate freely inside the cabinet which may slow the process of
cooling and make the cabinet less efficient.
• Defrost the appliance if frost can be seen building up inside - frost
will increase energy consumption and make the cooling process
slower.
• Turn the appliance off completely if it is not required for a period of
days or longer to avoid wasting energy (see also section ‘When not
in use’).
BASIC OPERATION
Your Husky Drinks Cooler must stand on an even, flat surface for quieter
operation.
If the appliance is to be placed on carpet, support it with a wooden board
underneath. Be aware that placing the appliance on carpet may mean that
heat from the compressor may cause the carpet to fade.
Thermostat settings
The settings 1 (MIN) – 5 (MAX) regulate the interior
temperature.
Setting 1 (or MIN) = lowest setting (warmest
internal temperature)
Setting 5 (or MAX) = highest setting (coldest
internal temperature)
1 2
H U S K Y D R I N K S C O O L E R
H U S K Y D R I N K S C O O L E R
1 3
To operate
1. Clean the inner compartment.
2. Plug in your Husky Drinks Cooler.
3. To turn the unit off, disconnect the plug from the mains supply.
NOTE:
If the unit is unplugged or power lost, you must wait 3 to 5 minutes
before restarting. If you attempt to restart the unit before this delay, the
unit will not start.
WARNING
If the thermostat is set to too cold a setting, beverages may become frozen.
In extreme circumstances, glass bottles may even break. Always exercise
caution when setting the temperature.
• Do not place heavy items (more than 20kg/44lbs) on top of the cooler.
• Do not place any items on top of the cooler which may fall off when
the door is opened.
• After the appliance has been unplugged, leave for three minutes
before plugging it in again.
When not in use
If the unit is not being used for long periods:
• Unplug your Husky Drinks Cooler.
• Clean and dry the inside of the appliance. Leave the door slightly
open to allow it to dry completely.
• A cooler which is unused without being cleaned may start to smell
musty or develop mildew.
DEFROSTING
• The surface of the evaporator ices up when the drinks cooler is working.
This is an entirely normal part of operation. If the frost layer is more
than 3mm/
1
⁄
8
” thick, the cooler must be defrosted and cleaned to
avoid unnecessary energy consumption and inefficient operation.
1. Remove all items inside and unplug the unit.
2. After defrosting, clean the unit (see instructions below) and allow it
to dry.
Cleaning
1. Unplug your Husky Drinks Cooler.
2. Wash the interior with warm water and neutral detergent.
3. Dry all surfaces thoroughly.
Note: Do not use abrasive cleaners!
To ensure efficient operation the back and bottom of the cooler should
be cleaned thoroughly. Use mild soapy water to clean the door seal.
Moving your Husky Drinks Cooler
• Unplug the appliance
• Remove all items inside
Note: Never hold the appliance by the door.
Power Failure
• If a power cut occurs, do not open the door more often than
necessary in order to conserve cold air.
