3
2
3. OPERATION
Never operate the worklight during charging.
A two-position ON/OFF toggle switch controls the operation of the worklight. The
worklight can be continuously lit for up to 40 minutes on a full battery charge
The worklight head swivels 180 degrees up and down, to accommodate most any
lighting situation. To release the swivel head from a locked position, simply rotate the
thumbscrew counter-clockwise to loosen. Then position the swivel head in the desired
position and tighten the thumbscrew to hold in place.
1
2
6
5
3
4
1. DC power socket
2. Adjustable thumb-screw for positioning
3. ON/OFF toggle switch
4. DC receptacle cord
5. Recharge LED indicator
6. Charge port
Figure 3. Location Diagram
An additional benefit of the worklight is the utility value of the clamp and hook
accessory shown in Figure 5. Utilizing this accessory provides many mounting
(positioning) options that will allow hands-free operation.
The most simple way to remove the lamp from the base:
1. Holding the lamp head (1) in place, rotate the base (3) of the unit counter-
clockwise.
2. Separate the Threaded Bolt (4) from the Threaded Bolt Hole (5).
NOTE
: The Thumb--Screw assembly (2) may be removed, but is not
recommended.
Attach the clamp and hook assembly to the lamp head (1) as follows:
1. Loosen the Clamp Thumb-Screw (5) and remove the Clamp Nut (6).
2. Align the Clamp Thumb-Screw (5) of the clamp and hook assembly with the
Threaded Bolt Hole (3) of the lamp head, and tighten well.
Figure 4. Lamp Assembly
4. AC CHARGING
Make sure the AC source is 120 volts, 60 Hz (a simple wall receptacle is 120 volts).
The worklight can be operated by its own stored power or with the coiled cord plugged
to a DC power source.
DO NOT OPERATE WORKLIGHT WHILE CHARGING
1. Lift the rubber plug from the charge port (6) on the worklight base.
2. Connect the AC charger/adapter to the recharge port.
3. Connect the AC charger/adapter to an AC power source or household wall
receptacle.
4. Charge for 25 - 30 hours. Red LED will light to indicate charging and will flash to
indicate a full charge.
5. After charging, disconnect the AC charger adapter from the power source and the
charge port and store the adapter.
6. Replace the rubber plug in the charge port to keep out dust and moisture.
Figure 5. Clamp and Hook Assembly
1
3
2
2
1
1. Lamp Head
2. Lamp Thumb-Screw
3. Threaded Bolt Hole
4. Clamp and Hook Assembly
5. Clamp Thumb-Screw
6. Clamp Nut
1. Lamp Head
2. Thumb-Screw Assembly
3. Lamp Base
4. Threaded Bolt
5. Threaded Bolt Hole
4
4
5
6
5
3
HSK142_Man_071405 7/20/05 4:16 PM Page 2
