8
Troubleshooting
Problem
Possible Cause
Solution
The tool runs slowly or will not
operate .
There is grit or gum in the tool .
Flush the tool with air tool oil or gum solvent .
The tool is out of oil .
Lubricate the tool according to the lubrication
instructions in this manual .
The air pressure is low .
□
Adjust the regulator on the tool to the
maximum setting .
□
Adjust the compressor regulator to the tool’s
maximum setting of 90 psi .
The air hose leaks .
Tighten and seal the hose fittings with pipe thread
tape if leaks are found .
The air pressure drops .
□
Ensure the hose is the proper size . Long
hoses or tools using large volumes of air may
require a hose with an I .D . of ½ in . or larger
depending on the total length of the hose .
□
Do not use a multiple number of hoses
connected together with a quick connect
fitting . This causes additional pressure drops
and reduces the tool power . Directly connect
the hoses together .
There is a worn rotor blade in the motor .
Replace the rotor blade .
There is a worn ball bearing in the motor .
Remove and inspect the bearing for rust, dirt, and
grit . Replace or clean and grease the bearing with
bearing grease .
There is moisture blowing out
of the tool’s exhaust .
There is water in the tank .
Drain the tank . (See the air compressor manual
for instructions .) Lubricate the tool and run it until
water is not evident . Lubricate the tool again and
run for 1-2 seconds .
The tool impacts slowly or not
at all .
The tool needs lubricating .
Lubricate the air motor and the impact mechanism
according to the lubrication instructions in this
manual .
The tool regulator setting is in the wrong position .
Adjust the regulator on the tool to the maximum
setting .
The tool impacts rapidly, but
will not remove bolts .
The tool has a worn impact mechanism .
Replace the worn impact mechanism components .
The tool does not impact .
The impact mechanism is broken .
Replace the broken impact mechanism
components .
