www.huskietools.com
6
OPERATING INSTRUCTIONS
COMPRESSION
1. Insert the plug end into a 120V power source. The LED indicator will flash red indicating the
charger is now in “stand-by” mode and ready to charge the battery. Do not plug the charger into a
generator as this will likely cause the fuse in the charger to short, and will not operate.
2. To charge a drained battery, insert the battery into the charger until the LED indicator shows a
steady green. This indicates the battery is being charged and will be completed in approximately
25 minutes. The LED indicator will show orange when charging is completed.
3. If the indicator shows a steady red when the battery is inserted, the battery is too hot to be
charged and must be cooled to room temperature before charging. Do not leave the battery in the
charger to cool as the charger will not recognize the battery is
inserted and will not charge.
4. If the LED indicator goes out or is flashing quick red, this could be a possible short in the battery
circuit, or a problem with the charger itself. It is best to consult the factory at 1-800-860-6170 for
service if such a condition occurs.
5. To recondition the battery, insert the battery into the charger and push the “R” button. The LED
indicator should be flashing green to indicate the discharge cycle is now in progress. The light will
turn steady orange when complete and the battery will have a full charge.
6. For technical questions or difficulty in operation, please call our customer service department at
1-800-860-6170.
