www.spartacogroup.com
800-860-6170
7
OPERATING INSTRUCTIONS
1. Insert the plug end into a 120V power source. The LED (Power)
indicator will be steady green indicating the charger is now in
“stand-by” mode and ready to charge the battery. Do not plug
the charger into a generator as this will likely cause the fuse in the
charger to short, and will not operate.
2. To charge a drained battery, insert the battery into the charger.
The LED indicator shows a steady amber while charging. A
depleted battery will be completely charged in approximately 50-
70 minutes. The LED indicator will show a steady green when the
battery is fully charged.
3. If the LED indicator goes out or is flashing quick amber, this
could be a possible short in the battery circuit, or a problem with
the charger itself. It is best to consult the factory at 1-800-860-6170
for service if such a condition occurs.
4. For technical questions or difficulty in operation, please call our
customer service department at 1-800-860-6170.
CHARGING THE BATTERY
1. While pressing the latch, pull out the battery cartridge. To replace the battery
cartridge, push the new cartridge firmly into place.
2. After inserting a battery cartridge, check that it is securely in
place by pulling gently. Do not press the latch when pulling the cartridge.
ATTACHING THE BATTERY CARTRIDGE
1. The ram advances when the trigger is pressed and stops when the trigger is
released.
2. To retract the ram, push the release button. The ram continues to retract while
the release button is pressed.
TRIGGER AND RELEASE BUTTON
