HUSABERG FE 450 AUS, Repair Manual

Page: 85 / 285

13/BRAKE SYSTEM
83
15.10
Checking the rear brake fluid level
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brakes according to the service schedule.
100402-10
–
Stand the vehicle upright.
–
Check the brake fluid level in the viewer

.
» When in the viewer

an air bubble is visible:
–
Add rear brake fluid. ( p. 83)
15.11
Adding rear brake fluid
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Skin irritations
Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brakes according to the service schedule.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
100403-10
–
Stand the vehicle upright.
–
Remove screw cap

with membrane

and the O-ring.
–
Add brake fluid to level

.
Brake fluid DOT 4 / DOT 5.1 ( p. 263)
–
Mount the screw cap with the membrane and the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.