HUSABERG FE 450 AUS, Repair Manual

Page: 115 / 285

30/ENGINE - WORK ON THE INDIVIDUAL PARTS
113
–
Press countershaft shaft seal ring

and shift shaft

in flush, with the open side
facing inward.
–
Mount and tighten oil jet

.
Guideline
Oil jet, piston cooling M5 2 Nm
(1.5 lbf ft) Loctite ® 243™
–
Mount the dowels.
–
Blow out all oil holes with compressed air and check that they are clear.
19.3
Removing the oil pressure regulator valve
300347-10
–
Remove plug

with sealing washer

.
–
Remove pressure spring

and ball

.
19.4
Checking the spring length of the oil pressure regulator valve
–
Remove the oil pressure regulator valve. ( p. 113)
200155-10
–
Measure the spring length of the oil pressure regulator valve.
Oil pressure regulator valve
Minimum length of pressure spring 23.5 mm (0.925 in)
» If the measured value does not meet specifications:
–
Change the spring.
–
Install the oil pressure regulator valve. ( p. 113)
19.5
Installing the oil pressure regulator valve
300347-11
–
Install ball

and pressure spring

.
–
Mount and tighten plug

with sealing washer

.
Guideline
Plug, oil pressure regulator valve M12x1.5 20 Nm
(14.8 lbf ft)
19.6
Removing the crankshaft seal ring in the clutch cover
300348-10
–
Remove the crankshaft seal ring in clutch cover

.