Technical Support (707) 544-4761
12
www.HURST-SHIFTERS.com
42. Ensure that boot is past the machined groove
on the pistol grip and is orientated in the right
direction. Secure the shift boot to the pistol grip
using the supplied tie wrap.
Note:
The pistol grip is designed so that the tie
wrap tightens down in the machined groove.
Note:
For clarity purposes for the following
procedures we left the isolation boot off.
Using grease or soap and water, place some
lubricant on the O-rings located on the lower stick.
With the shift boot still inverted, slide the pistol grip
down over the top of the lower stick. Ensure to
align the two holes on the pistol grip to the two
threaded holes on the lower stick.
44. Place the 1/4" isolation sleeves over the
1/4"x1/4”10-24 shoulder bolts.
43. Reinstall the factory isolation boot onto the
Hurst pistol grip as shown.
