Mounting Instructions:
• Select a mounting location best suited to your particular needs.
Mount as so the light housing(s) are at least 6” below the low tide wa-
terline.
• Depending upon your application use two desired length screws or
bolts thru the two studs to mount your mounting plate. Additional
mounting plates can be purchased in order to move your light from
berthing well to well.
• Any changes to the wiring must be carried out by a suitably qualified
electrician using ABYC guidelines. AC power supplies are IP67 (with
temporary submersion less than 1m).
• Sea-Vue Lights are equipped with an over temperature protection
circuit that will dim the lights if they inadvertently over heat. Ensure
the lens and backing plate are kept clean at all times. Failing to do so
will result in excessive heat build up and poor light performance. Do
not use abrasive or sharp objects to clean the housings and glass
lens.
Hint:
Spraying lights with Silicone or putting a thin layer of Petroleum
Jelly on annually will help keep algae, mussels, barnacles, etc. off.
• Dismantling this product voids warranty.
• Do not use as a step.
• Control Box must be
mounted on the external
part of the dock.
• Photocell Eye must be kept
clean and clear at all times.
• Lights can be redirected by loosening
the screws on the back of the housing(s)
to desired position.
Hurley Marine, Inc. • 906. 553.6249
[email protected] • hurleymarine.com
LED Sea-Vue®
Dock Light
