hurlcon Filtrite PZ303, Installation And Operating Instructions Manual

Page: 10 / 16

InstXXX Filtrite PZ303 Pool & Spa Pump V09_15
10
USE WITH SUCTION CLEANERS
When connecting a suction cleaner to the Filtrite pump, it essential that full prime is achieved on the pump prior to
connecting the cleaner hose. During operation at low speeds, the pump may only operate with partial prime in the
hair and lint pot chamber.
To operate a suction cleaner on your pump;
1. Choose the speed button (low, medium or high) on which the pump will operate when the suction cleaner
is connected.
2. Allow pump to operate for a minimum of 2 minutes to allow a full prime to be achieved.
3. Connect cleaner plate and hose to skimmer/wall suction only after all air has been purged from the top of
the hair and lint pot of your Filtrite Pump.
4. Adjust speed at which the cleaner will travel to all areas of the pool. Factory set medium speed will usually
operate all suction cleaner types in most pools.
5. When cleaner is no longer required, disconnect and remove hose/cleaner plate from system. Select the
lowest filtration speed that keeps your pool clean.
6. If replacing or selecting a new cleaner, it is recommended to purchase a robotic cleaner which operates
independently from the filter pump and allows the pump to operate at a speed which offers the maximum
energy (and cost) savings.
MAINTENANCE
Maintenance Schedule: You new product incorporates moving parts and withstands high velocity water
with chemicals in it. Some of these parts will wear in the normal course of use and require regular checks
and maintenance. Performing these checks and maintenance will identify parts that have worn and
require repair/replacement before further serious damage is sustained. A small amount of regular care
and attention to your pool equipment will help ensure long life and trouble free performance.
Timing Maintenance Check Service action (if required)
Weekly or sooner Check and empty hair and lint basket Empty leaves and debris
Three Monthly Check Lid O ring and inlet/outlet O rings for
leaks Isolate Pump, turn power off, clean and
grease O rings or replace if necessary
Three Monthly Check surroundings for leaves, debris and
flooding Remove debris and rectify if any
flooding
Three Monthly Check for leaks from underneath pump Call Service technician, repair or
replace mechanical seal and motor
bearings if necessary
Important note : Regular maintenance is important to ensure long life and trouble free performance of your pool
equipment. If unable to perform the maintenance yourself, contact your local Clark Rubber Store who will arrange
a trained service technician to perform the maintenance for you.