Hurco winmax, Programming Manual, Page: 149 / 254

WinMax Lathe NC Programming
704-0115-307
ISNC G Codes
4-35
G54-G59 - Work Coordinates (G54 default)
These modal commands select the work coordinate systems 1–6. The work coordinate
systems are affected by the work offsets, the shift offset, and the G50 - Set Part Setup or
Set Max RPM or G92 - Work Coordinate Offsets / Spindle Max Speed / Multiple Thread
Cutting Cycle command. Coordinate system 1 is the same as the part setup and it is the
default coordinate system. Coordinate systems 1–6 are established by manually entering
work offset values for G55–G59 on the Work Offset screen or with the G10 command.
Default—Yes
Modal—Yes
Cancels:
• G53 - Machine Coordinates
• G54-G59 - Work Coordinates (G54 default)
• G54.1 - G54.93 - Aux Work Coordinates
• G92 - Work Coordinate Offsets / Spindle Max Speed / Multiple Thread Cutting
Cycle
Use the G10 - Data Setting (Work Offsets, Tool Offsets, or Tool Geometry) command to
change work coordinate systems, and use the G50 - Set Part Setup or Set Max RPM or
G92 - Work Coordinate Offsets / Spindle Max Speed / Multiple Thread Cutting Cycle
command to set part zero. All six work coordinate systems can be moved an equal
distance and direction by using the G50 or G92 command.
Format
The format of the multiple work coordinates command is as follows:
G54 (Select work coordinate system 1)
G55 (Select work coordinate system 2)
G56 (Select work coordinate system 3)
G57 (Select work coordinate system 4)
G58 (Select work coordinate system 5)
G59 (Select work coordinate system 6)