HunterDouglas EverWood, Operating Systems

Page: 7 / 36

INSTALLATION
5
Mount the Installation Brackets — Inside or Ceiling Mount
Headrail Bracket Shims (Optional)
Headrail bracket shims are used to gain clearance for valance clips with inside or ceiling
mounts. One shim for each end bracket and two shims for each intermediate
bracket are included.
■
With each end bracket, first fold the shim and then position it on top of the end bracket to
gain the required clearance.
■
With each intermediate bracket, stack two
unfolded shims.
NOTE: Headrail bracket shims may also be
used to level the blind whenever the mounting
surface is uneven. The shims can be cut along
their fold line to make them fit.
Attach the End Brackets
With inside or ceiling mounts, attach the two end brackets flush against the sides of the
window casement or to the ceiling. Choose the most appropriate of the following mounting
methods:
■
Side/Top Mount (Inside mount only): Mount the end brackets with one screw through
a side hole and one screw through a top hole, as shown below left.
■
Side Mount (Inside mount only): Mount the end brackets with two screws through
diagonal side holes.
■
Top Mount (Inside or ceiling mount): Top mount the end brackets with screws through
the two top holes, as shown below right.
■
Ceiling mount only: If the end brackets are flush with the back wall, attach them with
one screw through a top hole and one screw through a rear hole.
■
Mark each required screw hole.
Single
Shim
Intermediate
Bracket
Side/Top
Mount
Top Mount