HunterDouglas EasyRise, Installation Operation Care

Page: 18 / 24

OPERATION
16
Problem EasyRise
™
shades only:
The universal cord tensioner has climbed to the
headrail.
Solution
Pull down on the spring to relieve tension and pull the
universal cord tensioner to the bottom of the cord loop.
Properly mount the cord tensioner. See “Attach the
Universal Cord Tensioner — EasyRise Shades Only”
on page 10 and/or the instructions included with your
Universal Cord Tensioner Installation Kit .
Problem EasyRise shades only: Shades raise at different rates when the cord is
pulled.
Solution
Depending on the size and weight of the shades, the clutch ratios may be
different. More cord travel is required with larger shades than with smaller
shades. This is completely normal, and not a defect of the product.
Problem The shade raises or lowers unevenly, or the bottom rail is uneven when
fully raised.
Solution
Check that the headrail is level. Level the headrail by shimming the installation
brackets, if necessary.
With Top-Down/Bottom-Up Shades only :
Check that the top of the fabric
(middle rail) is level. Adjust by hand.
Adjusting the Bottom Weight:
Access the weight on the back of the bottom rail.
Push up on the weight clips to release.
Slide the weight in 1" increments, toward the side where fabric is gathering.
Lower the shade all the way and check that the bottom rail is level. Adjust the
weight until the fabric winds evenly and does not gather on either side.
After final adjustments, slide the weight clips back into place.
Universal
Cord
Tensioner
Indicator
Line
Move Weight to Adjust
Weight
Clip
Weight Weight
Clip