INSTALLATION
4
Mount the Standard Installation Brackets — Outside Mount
Installation Brackets.
The installation brackets are
supplied in pairs. One bracket is used on the clutch side
with the beaded cord loop and the other bracket is used
with the idler side of the shade.
The installation brackets are always mounted so that the
inner surfaces face each other, as shown. The brackets
must be mounted so the shade is level when installed.
■
Center the shade over the window opening at
the desired height and make a mark on the end
of the clutch side of the shade.
■
Measure the width of the shade fabric. Mark the
width of the fabric plus 1¼" from the previously
made mark.
■
Place the outside edge of the clutch-side bracket on the first
mark, then mark the location of the screw holes.
■
Place the outside edge of the idler bracket
on the second mark, then mark the location
of the screw holes.
➤
The top of the installation brackets
should be at the desired height. The
brackets should be level and aligned.
IMPORTANT:
The front edges of the
installation brackets must be level and
aligned to each other.
■
Use a
1
∕
8
" drill bit to drill the screw holes.
IMPORTANT:
Do not mount into drywall,
only mount into studs.
■
Use a level to check that the mounting surface is level. Shim the brackets if necessary.
Shims are not provided.
■
Attach the installation brackets using the screws provided.
➤
If the shade is ceiling mounted, the screws are placed vertically when mounting the
bracket to the ceiling.
Proceed to “Install the Cables” on page 7.
Clutch
Side
Idler
Side
Ceiling Mount
Holes
Outside
Mount Holes
Measure
Add 1¼"
Summary of Contents for Designer Screen Patio Shade
Page 19: ......
