8
1886
Ceiling Bracket
Hanging Fan
Wiring
Installing Fan Body
Blades
Light
Remote
Installing the Bulbs and Glass
Assembling the LIght Kit
Fan style may vary.
Note:
Fan style may vary.
Note:
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the trim ring to the mounting plate.
Connect the single-pin
connectors from the
light kit assembly to the
connectors from the fan.
Connect the white wires
together. Connect the blue
and black wires together.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
WARNING
GLASS FALL HAZARD
To prevent
SERIOUS INJURY
or
DEATH
, make
sure that glass is properly secured.
Assembling the LIght Kit
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
2 of 2
Short Light Kit
Screw
BAG
Insert the third screw, found in the
hardware
bag, in place and firmly tighten all the three screws.
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the
hardware bag.
Feed the wire plugs through the center
hole of the upper switch housing, then
wrap keyhole slots around the screws
and twist counterclockwise.
