44276-01 02/18/2013
7
2.
3.
4.
5.
6.
2.
1.
3.
4.
5.
6.
Fasten the canopy directly to the top of the fan motor housing with the three screws provided. (The downrod and
ball are not used for this installation). (Fig. 9A) If a metal ring washer with three holes is provided, use it to install
the canopy.
Hang the canopy (with the fan motor housing attached) from the tab on the hanger bracket (Fig. 9B). This will
allow you to make the electrical connections without having to hold the fan up.
Make the wire connections (refer to section titled “Electrical Connections”).
Put two screws in the hanger bracket, leaving them partially out (Fig. 9C).
Place the canopy up on the hanger bracket by inserting the slotted opening of the canopy on the screws (Fig. 9D).
Insert the remaining screws through the remaining canopy holes and tighten all four screws.
WARNING: Failure to completely tighten the screws in step 1 could result in fan loosening and possibly falling.
