10
System and Controller Wiring
Manual Pairing the Wireless Receiver/Sensor
The Wireless Solar Sync receiver and sensor are already
paired with the same frequency for an easy installation.
When installed, the wireless receiver will automatically go
into a "search" mode looking for the signal from its paired
sensor. However, it is a good idea to initialize communication
manually between the wireless receiver and sensor during
installation to verify correct signal transmission.
Initialize Communication Manually Between Wireless
Receiver and Sensor
1. After the receiver's green and black wires are connected
(see "Wiring the Sensor/Receiver to Hunter Controllers"
section), restore power to the controller.
The red LED in the center of the wireless receiver will
turn on and stay solid for 10 seconds, indicating that it
is searching for a signal from a wireless sensor.
2. While the red LED is solid and the wireless receiver is in
search mode, press and hold the spindle on the wireless
sensor. The LED in the wireless receiver will blink four
times and then turn off, indicating that the signal from
the wireless sensor has been acknowledged.
