56
PROGRAMMING THE PSC-Z CONTROLLER
Moving About the Display .................................
Use the four buttons in the center of the control panel to move
about the display:
Press to move from field to field.
Press to change the flashing value,
The active field flashes.
or to select days.
Set Clock and Day ............................................
Press
TIME
DAY
To display:
• Set time and day before
setting up watering schedules.
• Set time to AM, PM, or 24-hour.
Set Station Run Time, Cycles, and Days Apart .....
Press
STATION
To display:
For each station,
you can set:
• Cycle length
(from 1 min.
to 3 hrs., 59 min.)
• The PSC-Z waits at least 30 min. between cycles to allow water to soak
into the soil. To change the automatic cycle delay time for either program,
hold down START TIMES for 4 secs.
• Set all cycle times to zero on unused stations.
• You can enter new station settings at any time, even while water is running.
• The PSC-Z has a supplied schedule that it will run if you do not set one
up, or if power is lost, there is no battery, and the internal power storage
capacity is exhausted (after 10 hours without power or backup battery).
Cycle
Cycles
Days
Start
Cycle
Program
Time
per Day
Apart
Time
Delay
A
10 min.
1
1
1 am
30 min.
B
1 min.
1
1
0:FF
30 min.
LAST
NEXT
LAST
NEXT
AM
SUN
• Days between
waterings
(from 1 to 14)
STATION
PROGRAM A
CYCLES
PER DAY
CYCLE TIME
DAYS
APART
NEXT WATER WED
• Number of
cycles per day
(from 1 to 14)
