7
1886
1886
Ceiling Bracket
Hanging Fan
Wiring
Motor Housing
Blades
Light
Control
Installing the Remote Control Cradle
Option 1: Using Adhesive Strip
Option 2: Using Screws
You have two options for installing the remote cradle.
Choose which path works best for you.
Remove the cradle from
the cradle bracket.
Slide the cradle onto
the mounted bracket.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Choose your cradle
installation location.
Separate the lining
from the back of the
adhesive strip on
the cradle bracket.
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Preparing the Remote
Phillips
Head
Screw
Battery
Door
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
NOTICE
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to
be used for an extended period of time.
• Remove used batteries promptly.
ON
Turn P
ow
er
To close the battery
compartment, secure
the battery door to the
transmitter assembly with
the small Phillips head screw.
Replace with a CR2032
battery when necessary. The
battery should be installed
with the positive (+) side up.
Fan On/Off
+ Quick Press
Light Dimming
+ Long Press
+
+
Light On/Off
+ Quick Press
Long Press
Long Press
Fan Updraft
Fan Downdraft
Raise Fan
Speed
Lower Fan
Speed
+ Quick Press
+ Quick Press
Key Press
Function
Dimming Mode
On/Off
Long Press
Enable Beep
Disable Beep
+
+
+
Long Press
Long Press
