6
41473-01 12/6/2001
STEP 4 - ASSEMBLING
THE FAN
Use the Step 4 instructions for the type of mounting you
have selected: standard, angle, or flush.
STANDARD AND ANGLE MOUNTING
For Standard 8-foot Ceilings and Higher
1. Insert the pipe through the canopy as shown in Fig-
ure 4a. Feed wires from the fan through the pipe.
2. Screw pipe into fan assembly until tight.
IMPORTANT!
Tighten pipe setscrew as shown in Figure 4a.
Figure 4a - Inserting Pipe through
Canopy
Pipe
Canopy
Pipe
Setscrew
Figure 3c - Attaching Ceiling Plate to
2 x 4 Brace
2 x 4 Brace
Ceiling Joist
Ceiling
Outlet Box
Ceiling
Plate
Flat
Washer
3" Wood
Screw
5. Place a flat washer on each of the two 3" screws and
pass the screws through the slotted holes in the ceil-
ing plate as shown in Figure 3c.
6. Tighten the screws into the 9/64" pilot holes; do not
use lubricants on the screws. Do not overtighten.
STEP 3 - INSTALLING THE
CEILING PLATE
1. Drill two pilot holes into the wood support structure
through the outermost holes on the outlet box. The
pilot holes should be 9/64" in diameter.
2. Thread the lead wires from the outlet box through
the hole in the middle of the ceiling plate.
3. Your fan comes with two neoprene noise isolators.
Position the isolators between the ceiling plate and
ceiling by inserting the raised areas on each isolator
into the holes in the ceiling plate. Refer to Figure 3a.
Figure 3a - Adding Isolators to Ceiling
Plate
Figure 3b - Correct Position of Ceiling
Plate for Angle Mounting
Ceiling Plate
Hooks
Isolators
Ceiling
Plate
4. Align the slotted holes in the ceiling plate with the
pilot holes in the wood support structure. Note: The
isolation pads should be flush against the ceiling.
For Angle Mounting Only: Be sure to orient the
ceiling plate so that the two hooks point up towards
the ceiling peak as shown in Figure 3b. Note: You
will use the hooks to support the fan during STEP 5 -
WIRING THE FAN.
CAUTION
The pipe has a special coating on the threads. Do
not remove this coating; the coating prevents the
pipe from unscrewing. Once assembled, do not
remove the pipe.
