Hunter ICR, Owner'S Manual And Installation Instructions

Page: 13 / 32

8 9
2. Press the Mode button until the
word “Max Station” appears
on the display. The maximum
number of stations will be
blinking at this point.
3. Use the or button to increase or decrease the
maximum number of stations from 1 to 48. Then do not
touch any of the buttons for 5 seconds and the display
will stop blinking and return back to the active station.
PREPARING THE RECEIVER FOR USE............................................................
As stated earlier, your ICR is designed to work right out of
the box. If you have decided to change your Transmitter
address as described in the previous section, you must allow
the Receiver to “learn this new address. Once learned, the
only way to remove the address from the Receiver memory
is to learn a different address. This can be done by following
the simple steps outlined below.
Changing the Receiver Address
1. Hold down the single button on the face of the Receiver
while you are plugging it into an active SmartPort
®
wiring harness (one connected to a powered controller).
When this is done the Receiver will beep 4 times.
2. After the Receiver starts to beep, release
the button.
3. Press either the “ON” or “OFF” button on
your transmitter.
4. The Receiver will beep 4 additional times
indicating that it has learned the new Trans-
mitter address and will respond only to it
from this point on.
MAX STATION