32
hunter.direct/ICC2help
Hidden and Advanced Features
TOTAL RESET
The Total Reset feature will erase all of the controller’s
memory and set everything back to factory presets. Once you
perform a Total Reset, all programming will be completely
erased, including any Easy Retrieve programming that may
have been saved. This feature is typically utilized when you
need to reprogram the controller from the beginning, or if the
controller is not responding to any commands.
1.
Press and hold the PRG and RESET buttons
simultaneously. Wait until the display shows 12:00 AM,
and release both buttons. The controller is now ready
to be reprogrammed.
QUICK CHECK
™
This circuit diagnostic procedure can quickly identify wiring
shorts commonly caused by faulty solenoids and poor or
incorrect wire splices. Quick Check is an efficient and effective
way to diagnose problems in the field, instead of having to
physically check each wiring circuit for potential problems.
1.
To initiate the Quick Check test procedure, press the +, –,
►, and ◄ buttons simultaneously. The display will show all
icons on the screen.
2.
Press the + button to begin the diagnostics. The controller
will then search all stations to detect a high current path
through the station terminals. When a field wiring short
is detected, an “ERR” message, preceded by the station
number, will flash momentarily on the display. The test will
continue checking the remaining stations for faults, and
once completed, will return to automatic watering mode.
RUN PROGRAM (ONE-TOUCH MANUAL START)
ICC2 is also capable of activating an entire program without
using the dial. This option is great for a quick cycle when extra
watering is needed or if you would like to scroll through the
stations to inspect your system. The Run Program Feature
differentiates from the Test Program feature by being able to
select any of the four automatic programs to run their existing
run times.
1.
With the dial in the Run position, press and hold the ►
button for two seconds and release.
2.
This manual one touch start option automatically defaults
to program A. You can select any of the four programs
(A, B, C, or D) by pressing the PRG button.
3.
The station number will flash on the display. Press the ►
and ◄ buttons to scroll through the stations, and the +
and – to adjust the pre-existing run times (0 minutes up
to 12 hours). Once you’ve selected your desired station to
run first, the program will begin automatically. You can
advance forward and backward through the stations if you
don’t need a particular zone to run for the full duration.